Your Machine At A Glance; Fitting; Operation - Hurricane DT5307 Manual De Instrucciones

GB
If the mains cable is damaged, pull out
the plug.
Do not expose the machine to moisture.
Double insulation.
Waste electrical products should not be
disposed of with household waste.
The product complies with the
applicable European directives and an
evaluation method of conformity for
these directives was done.
Protected against splashing water from
any direction.
DANGER! Risk of cutting hands and
feet by tool.
Guaranteed sound power level.
Personal safety equipment
Wear ear defenders
Wear safety shoes
Wear safety goggles
Wear protective gloves

Your machine at a glance

► P. 3, item 1
1. Trigger
2. Handle bar
3. Handle bar, middle part
4. Handle bar, bottom part
5. Protective flap
6. Knob for working depth adjustment
7. Bag for cuttings
8. Strain relief mechanism for extension cable
9. Operating safety lock
What is included
• Instructions for use
• Scarifier
• Handle bar
• Handle bar, middle part (2×)
• Handle bar, bottom part (2×)
• Collection sack
• Mains plug strain reliever
• Bag with small parts

Fitting

Mounting the handle
► P. 3, item 2
- Insert the lower handle into the mounting holes.
Then insert the fix bolt and tighten.
- Position the middle part of the handle bar (3)
onto the bottom part of the handle bar and
push through the carriage bolts (11).
- Apply the wing nuts (12) and tighten.
► P. 4, item 3
- Push the cable grip (8) onto the handle bar (2).
- Position the handle bar (2) onto the middle
part of the handle bar and push through the
carriage bolts (13).
- Apply the wing nuts (14) and tighten.

Operation

Check before use!
DANGER! Danger of injury! Do not operate
the machine unless you did not find any faults.
If a part has become defective, make sure to
replace it before you use the
machine again.
Check the safe condition of the machine:
- Check it for visual defects.
- Check that all parts of the machine have been
securely fitted.
Adjusting the working depth
Depending on the wear on the working roller,
the setting can be modified (working depths: ►
Technical data – p. 21).
► P. 3, item 1
- Switch the machine off.
- Raise the machine at the front.
- Adjust the desired depth of the working roller
using the knob (6).
- Lower the machine again.
Attaching the cuttings bag
► P. 4, item 4
20