STEP 1
Use the provided template to mark
the hole locations for the pivot
brackets in the top and bottom of
the cabinet
(See Figures A-1 and A-2).
STEP 2
Install the top pivot bracket,
detent stop and bottom pivot
bracket in the marked locations
from step 1 using (8) 8 x 5/8"
truss head screws
(See Figures B-1 and B-2).
#2
STEP 3
Install the nut and screw to the
arrester hub (See Figure C-1)
before attaching to the tray.
Attach the arrester hub to the
bottom of the arrester tray as
shown using (4) 8 x 5/8" truss
head screws in the pre-drilled hole
locations.
Note: Position arrester hub with
post mounting screw hole to the
right side of the tray
(See Figure C-2).
#2
STEP 4
Install the nut and screw to the
top hub (See Figure D-1) before
attaching to the tray. Attach the
top hub to the bottom of the
upper tray using (4) 8 x 5/8"
truss head screws in the
pre-drilled hole locations.
Note: Position the hub so the
rounded opening lines up with
the post mounting screw hole
(See Figure D-2).
#2
STEP 5
Install the detent hub to the
bottom of the bottom tray as
shown using (4) 8 x 5/8" truss
head screws in the pre-drilled
hole locations.
Note: Position the notch in the
hub on the right side of the tray
(See Figure E).
#2
2
FIG. A-1
FIG. B-1
FIG. C-1
Install nut and screw
before attaching to tray
FIG. D-1
Install nut and screw
before attaching to tray
FIG. E
Customer Service: 800-626-1126 | rev-a-shelf.com
FIG. A-2
FIG. B-2
FIG. C-2
FIG. D-2
Notch
Post Mounting Screw
Rounded Opening