Inserting Batteries - LaserLiner DigiLevel Plus Manual De Instrucciones

1

Inserting batteries

Open the battery com-
partment and insert
batteries according
to the symbols. Be
sure to pay attention
to polarity.
2
Switching on and measuring
!
Make sure that the reference function
is deactivated before measuring.
The DigiLevel Plus can measure angles continuously
to 360°.
– Switch the DigiLevel Plus on using the on/off switch (4).
– The slope angle is shown in the display (8). If slopes
are measured overhead, the direction of display
adjusts automatically.
– The current slope direction is also shown by
the symbol (7).
3
Selection of unit of measurement
Button (5) allows the desired unit of measurement to be
selected (° degrees, %, mm/m).
4 Calibration
1. Place the measuring face (17) on an even surface with
position mark (see Fig. below). Switch on device (4) and
keep the CAL button (3) pressed until CAL 1 appears
on the display.
2. Press the CAL button (3) again. CAL 1 flashes. The
display then switches to CAL 2 and a signal sounds.
3. Now turn the spirit level vertically by 180° and
place exactly on the marked surface (reverse
measurement).
4. Press the CAL button (3) again until CAL 2 flashes.
The subsequent acoustic signal concludes the process.
The unit is properly calibrated when it displays
!
the same measurement value, i.e. the underlying
surface's deviation from absolute level, in both
positions (0° and 180°).
DigiLevel Plus
07
GB