Panasonic ER214 Manual De Operación página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
6 Cleaning
Ensure that the switch is turned off.
Removing the blade
1 Press the blade.
Maintenance
2 Remove the beard cuttings.
3 Press the lever (a) and remove
the beard cuttings from between
the blades.
4 Apply 1 or 2 drops of oil to the
places indicated by the arrows.
Attaching the blade
5 Insert the projection on the blade
into the depression on the body.
6 Press until you hear a click.
7 Exchanging the shaver
head (ER216 only)
Removing the trimmer head
1 Press both buttons.
2 Remove the trimmer head
(shaver head).
Attaching the shaver head
3 Attach the shaver head while it is
still in the protective cap and
press until you hear a click.
4 Remove the protective cap.
Shaving around the beard
5 Pay extra attention when shaving
around the beard.
If the trimmer head is used, 0.6 to
0.8 mm of hair is left. If the shaver
head is used, the remaining hair can
be shaved.
(Hair longer than this may not be
shaved neatly.)
Cleaning the shaver head
6 Lift the set lever with a finger nail.
7 Remove the inner blade.
OS01L015_ER214-ER216_E
8 Clean the inner blade and outer
blade.
9 Reassemble.
10 Lubricate.
• In order to prevent oil residue or oil
on the blade surface from getting
on your skin, wipe excess oil off
with a tissue before using the
shaver for the first time and after
lubricating it.
• The oil will not affect your skin.
8 Removing the Ni-MH
battery for disposal
Disconnect the trimmer from the out-
let when removing the battery.
* Fully discharge the battery.
1 Remove the trimmer head
(shaver head).
<Use the head exchange but-
ton.>
2 Remove the metal plate.
<Use a flat-tipped screwdriver.>
3 Remove the screw (PTP2×8).
<Use a Phillips screwdriver.>
4 Remove the housing (A and B).
<Use your hands.>
5 Remove the motor and circuit
block.
<Use your hands.>
6 Remove the battery (for recy-
cling).
<Use your hands.>
9 Life of the blade and
battery
Blade Life
Blade life will vary according to the
frequency and length of use. For ex-
ample, using the unit for 10 minutes
every 3 days, the life expectancy is
approximately 3 years. If cutting effi-
9
9
1/17/02, 4:43 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Er216

Tabla de contenido