Product Specifications - GYS PORTASPOT 230 Manual De Instrucciones

Maximum welding rate without thermal activation at ambient temperature of 20°C, when in simple im-
pulsion in AUTO mode:
Spotting with simple impulsion in AUTO mode
0.6 mm + 0.6 mm
0.8 mm + 0.8 mm
1 mm + 1 mm
1.2 mm + 1.2 mm
1.5 mm + 1.5 mm
2 mm + 2 mm
ANOMALIES, CAUSES, SOLUTIONS
The welding spot does not hold:
- The power supply is faulty (low voltage, inadequate extension, faulty electrical outlet)
- Welding parameters (strength and diameter of the electrodes, welding time) are not suitable for the task being performed.
- Elements that are part of the secondary circuit (carrier arm / arm / electrode holder) are ineffective because of loose or oxidised screws.
PX ARMS TECHNICAL SPECIFICATIONS
Arm
PX1
PX2
PX3
PX4
PX5

PRODUCT SPECIFICATIONS

CARACTÉRISTIQUES ÉLECTRIQUES
U rated power supply voltage
1N
Frequency
U rated no load voltage
20
Permanent power U
SP
Permanent supply current I
Maximal current of a permanent primary short circuit I
Maximal current of a secondary short circuit I
Permanent secondary current I
Type of welding current
THERMAL SPECIFICATIONS
Operating ambient temperature
Storage and transport operating ambient
MECANICAL SPECIFICATIONS
Fmax maximum welding force
Protection rating
Dimensions
Weight
Range of distance of the arms e
Range of length of the arms l
F1min minimum welding force
PORTASPOT 230
Clamping force (daN)
minimum
30
25
25
15
30
1p
2cc
2p
without thermal protection activation - 20°C "
maximum
120
80
80
50
120
1cc
"Maximum welding rate
1 spot every 20 sec.
1 spot every 25 sec.
1 spot every 30 sec.
1 spot every 45 sec.
1 spot every 1 mn 10 sec.
1 spot every 2 mn 10 sec.
Welding intensity (A)
6300
6050
6050
5800
6300
1 ~ 230 V
50/60 Hz
2.45 V
1.25 kVA
5.3 A
67 A
6300 A
500 A
De + 5°C à + 40°C
De -25°C à +55°C
120 daN (270 lbf)
IP 20
Without arms :
L : 36 cm x l : 10 cm x h : 29 cm
L : 14.2 in x l : 3.9 in x h : 11.4 in
10 kg
90 mm (3.5 in)
De 110 mm à 350 mm
30 daN (67 lbf)
EN
17