Publicidad
Idiomas disponibles
Idiomas disponibles
4. Connect the supplied Power Adapter and power on.
5. Check the LEDs
The Status LED should flash, and then turn off. If it
stays on, there is a hardware error.
The WAN LED should be ON.
For each active LAN (PC) connection, the LAN
Link/Act LED should be ON.
Configuration
1. Start your PC. If it is already started, restart it.
It will then obtain an IP Address from the VPN Broadband
Router's DHCP Server.
2. Start your WEB browser. In the Address box, enter the
following:
3. Click WAN Wizard to proceed initial setup
4. Step through the Wizard until finished. Refer to the data
from your ISP, and the table below, as necessary.
Connection Type
Dynamic IP Ad-
dress
Specified (Fixed)
IP Address
PPPoE
PPTP, L2TP, Big
Pond
5. On the final screen of the Wizard, run the test and check
HTTP://192.168.0.1
Data required.
Usually, none.
But some ISPs may require a
Hostname, Domain Name, or
MAC (physical) address.
IP Address allocated to you,
and related information.
Login name and password.
Login name and password,
Server IP Address
Publicidad
