FLAEM Aspira Instrucciones Para El Uso página 10

Ocultar thumbs Ver también para Aspira:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
power cable. Repairs must be done only by authorised FLAEM personnel. Unauthorised repairs void the war-
ranty and may be hazardous for the user.
ATTENTION: Do not modify this device without authorisation from the manufacturer.
mance only if: a) the device is used in compliance with the instructions for use b) the wiring where the device
is being used is in compliance with safety regulations and current laws.
tion.
the pump. Should this occur, immediately switch off the suction machine, then empty and clean the canister
(send it to an authorised FLAEM service centre).
carry out the cleaning procedure.
contagious infection.
after each use.
FLAEM NUOVA declines any responsibility for harm to the patient correlated to the deterioration of the afore-
mentioned sterile packaging due to third party handling during the original packaging of the entire device.
(*)The hydrophobic antibacterial/antiviral filter is single use. The filter used by the same patient must be
replaced every 24 hours. ATTENTION: the hydrophobic antibacterial/antiviral filter must be replaced for each
new patient.
INSTRUCTIONS FOR USE
Before each use, the accessories must be carefully inspected to ensure the absence of dust, incrustation, clots or
liquid substances both inside the connecting tubing and in the canister and its respective lid. Furthermore, they
must be cleaned following the instructions rigorously as stated in the "CLEANING, SANITISATION, DISINFECTION,
STERILISATION" paragraph. We recommend personal use of the accessories, the collection canisters and the con-
necting tubing to prevent risk of contagious infection.
Instructions for suction on the patient:
1. Connect the accessories, referring to the "CONNECTION DIAGRAM" on the cover.
ATTENTION: in addition to being antibacterial/antiviral, the hydrophobic filter also acts as secondary line of
safety and stops any fluids that the primary safety device in the canister lid accidentally does not stop.
Follow the directions below for proper assembly:
SCRIPT:
IN
Side to connect to the VACUUM
inlet (12) of the collection canister
SCRIPT:
Lato aspiratore- Aspirator side
10
Side to connect to the AIR INLET
of the suction machine
-
-

Publicidad

Tabla de contenido
loading

Tabla de contenido