Charging The Power Supply Unit For The Ds210 & M210Se; Inserting The Battery Into The M210Se Handheld Terminal - ACD M210SE Manual De Instrucciones

3.2.1 Charging the Power Supply Unit for the DS210 & M210SE
The M210SE and the spare battery may only be charged in the DS210 docking station with the respective
power supply unit.
•
External power supply unit for DS210
•
Input voltage
•
Output voltage
•
Power cable (country-specific)
ATTENTION

3.2.2 Inserting the Battery into the M210SE Handheld Terminal

The battery compartment is located at the rear end of the device. In order to open the cover, first remove the
transverse hand strap by unhooking it. Now push the locking tab on the battery compartment cover towards
the cover surface. The compartment then opens.
The battery can be inserted without the use of force. The long groove on the unlabelled side of the
battery is the top side. The opening of the groove faces the recess for the opening mechanism. In doing so,
ensure that you insert the battery at a slight incline towards the contacts and then bring it into its final
position while applying a slight amount of pressure. You can see how to insert the battery in Figure 3. First,
place the cover on the three securing straps and then push into the locking mechanism.
Figure 3: Inserting the Battery
M210SE_Lidl_Brief_Overview_FCC_V1.04_en_es.doc
~
100 – 240 V AC; 0.8 A; 50 – 60 Hz
15 V DC; 2.4 A
Unintended use of the interfaces should be avoided.
8 / 32