Pre-Installation Information; Check Contents - Bradley S19-200 Instrucciones De Instalación

Lavaojos personal con montaje en grifo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Model No. S19-200 Faucet-Mount
Eyewash Parts List
6
5
Item
Part No.
Qty
Description
1
107-450
2
Dust Cover
2
S90-350
1
Yoke Assembly
3
130-140
1
Allen Wrench
4
160-131
1
Set Screw
5
S27-290
1
Diverter Assembly
6
S65-154
1
Threaded Adapter Kit
7*
S65-153
1
Gasket Kit
8*
204-486
1
Emergency Sign
9*
204-421
1
Inspection Tag
* Not shown

Pre-Installation Information

Check Contents

Separate all parts from the packaging and check each part
1
with the parts breakdown on the preceding panel. Make
sure all parts are accounted for before discarding any
packaging material. If any parts are missing, do not
attempt to install your Bradley Faucet-Mount Eyewash
Unit until you obtain the missing parts.
Supplies Required:
2
• Wrench
• Standard or Gooseneck Faucet with 55/64"x 27 thread,
15/16"x 27 thread or 13/16"x 27 thread connections.
Note: Due to the many types of faucet designs
available, the enclosed thread connections may
not fit your faucet. It may be necessary to purchase
the correct thread connections locally. Bradley has
provided a 55/64"x27 thread connection on the
4
Faucet Mount Eyewash adapter. Two additional
thread connections (15/16"x27 and 13/16"x27
thread) have been provided to fit most common
faucet designs. For additional adapter sizes,
3
please contact Bradley.
• Cold or tempered water supply (minimum 30 PSIG)
WARNING: To prevent scalding of the
eyes when eyewash is in use, it is
recommended that hot water supply
be disconnected OR that tempered
water be provided. A comfortable
eyewash water temperature range is
15° C - 35° C (60° F - 95° F). In
circumstances where chemical
reaction is accelerated by water
temperature, a facilities safety/health
advisor should be consulted regarding
the optimum temperature for each
application*.
*ANSI Z358.1-2004
Step 1: Installing adapter
1. Remove the existing aerator from the faucet (see
Figure 1).
Figure 1
2. Screw the Faucet Mount Eyewash adapter onto the
faucet and tighten with a wrench (see Figure 2).
Actuator Pin (A) must be facing front, toward the user.
Note: To prevent scratches on the Eyewash adapter,
it is recommended a grip pad or cloth be placed
around the adapter while tightening with wrench.
A
Figure 2
215-1212 Rev. G; ECN 07-522
10/1/07
page 2 of 6

Publicidad

Tabla de contenido
loading

Tabla de contenido