Dhcp - FAA EDC 01L Manual Del Usuario

EN
Translation of the original instructions
• IP ADDRESS ASSIGNMENT FOR DOOR CONTROLLER LAN
• DHCP ENABLE
!
The Door Controller goes out of factory configured with active DHCP.
This function is available from the Door Controller firmware version 01.01.01 K
or higher and Keydom software 1.1.0 or higher.
With lower Software or Firmware versions see DHCP DISABLED section.
If the DHCP service is not available in your network, you must change the configura-
tion of the Door Controller (see chapter Configuration - Function 3).
To configure the IP address, Subnet Mask, Gateway, and the Door Controller
Identification Number, install and power all Door Controllers, access the Key-
dom software in the Configuration - Devices - Device Discovery (follow the
Keydom software manual for use).
Once a fixed IP address is assigned, the DHCP function is automatically disabled.
• DHCP DISABLED
With DHCP deactivated
to modify the parameters, you must use the Door Controller Web Interface by
accessing the IP address configured.
Default IP address: 192.168.1.240
L L
Door Controller
(see chapter Configuration - Function 3 Disabling/Enabling DHCP)
18
,
2
532226 - Rev. D