FAA EDC 01L Manual Del Usuario página 28

EN
Translation of the original instructions
Function 2 - View and modify the RS485 baud-rate.
Enable the function by pressing the Programming Button.
Turn on the "LED 2"- press and hold the button until all the LEDs flash, release it.
LEDs 1 to 5 indicate the set configuration.
To change it, press the button by selecting the desired Baud rate, to confirm
press the button again until all the LEDs start to flash.
Function 3 - Disabling / enabling DHCP.
Enable the function by pressing the Programming Button.
Turn on the "LED 3" - press and hold the button until all the LEDs flash, release it.
By releasing the button, you can check the current configuration status.
LED 1 flash = DHCP function disabled
LED 2 flash = DHCP function enabled
change the current status by pressing the programming button, to confirm
press the button again until all the LEDs start to flash.
Function 5 - Clear settings and archives.
When the "clear settings" function is accessed, all configurations will be reset
to their default values and all archives reset; the communication parameters
will remain unchanged.
Enable the function by pressing the Programming Button.
Turn on the "LED 5", - press and hold the button until all the LEDs flash,
release it and to confirm the deletion, press the button until you start flashing
all the LEDs.
Function 6 - Restore Default.
Clear settings, archives and connection parameters (LAN and RS485).
When the function is accessed, all configurations will be reset to their default
values and all archives will be deleted.
Enable the function by pressing the Programming Button.
Turn on the "LED 6", press and hold the button until all the LEDs flash,
release it and to confirm the deletion, press the button until you start flashing
all the LEDs.
Exiting from programming mode without saving :
Door Controller
LED
1
2
3
4
5
wait 10 seconds for the timeout.
26
Baud-rate
19200
38400
57600
115200
230400
532226 - Rev. D