Task 2: Mounting Vess R2600 In A Rack - Vess R2000 Serie Guia De Inicio Rapido

TASK 2: MOUNTING Vess R2600 IN A RACK

The instructions here apply to the Vess R2600 and Vess J2600 series.
Cautions
* Do not populate any unit with hard drives until it has been securely installed in
* At least two persons are required to safely lift, place, and attach the Vess
* Do not lift or move the Vess R2600 or Vess J2600 unit by the handles, power
* Do not install the Vess R2600 or Vess J2600 unit into a rack without rails to
* Only a qualified technician who is familiar with the installation procedure
* Mount the rails to the rack using the appropriate screws and flange nuts, fully
* Do not load the rails unless they are installed with screws as instructed.
* The rails available for the PROMISE Vess R2600 or Vess J2600 unit are
* PROMISE Technology, Inc. cannot guarantee that the mounting rails will
The Vess R2600 or Vess J2600 installs to the rack using the mounting rails shipped with the device.
Note
To lighten the Vess R2600 or Vess J2600 enclosure, you can remove the power
supplies. Replace the power supplies after the Vess R2600 or Vess J2600 unit is
mounted in your rack.
the rack.
R2600 or Vess J2600 unit into a rack system.
supplies or the controller units. Hold the subsystem itself.
support the subsystem.
should mount and install the Vess R2600 or Vess J2600 unit.
tightened, at each end of the rail.
designed to safely support that PROMISE Vess R2600 or Vess J2600 unit
when properly installed. Additional loading on the rails is at the customer's risk.
support your PROMISE Vess R2600 or Vess J2600 unit unless you install
them as instructed.
9