Philips SHG8100/00 Manual De Usuario página 12

ENGLISH
12
No sound /
distorted sound
Headphone power off
No battery installed
Wrong battery orientation
No power supply to transmitter
Battery power running low
Audio source not connected
Audio source is off
Volume level set too low
Audio output level low
Headphone not tuned to
the transmitter
Interference from other
radio sources
Headphone too far away
from transmitter
Transmitter other than
SHG8100 is used
Switch on the POWER button of the
headphone.The POWER STATUS light
will be illuminated in red.
Follow step 1 to 4 of 'Installing/replacing
the batteries'
Reposition the batteries according to the
engraved polarity symbol.
Make sure the docking station is
connected to the local mains power
supply through an adapter and follow
step 5 to 7.
Follow step 8 to 10 to recharge the
headphone.
Make sure the audio output of your audio
source is connected to the RCA audio in jack
of your transmitter. Follow step 11 to 16.
Turn on your audio source.
Adjust the volume level of your audio
source or the headphone.
Hearing Safety: Continuous use at a
high volume may permanently damage
your hearing.
In case of audio sources with adjustable
output level, adjust the output level to a
higher and non-distorted level.
IMPORTANT: In case of certain TVs, the
headphone jack output level can only be
adjusted after accessing the TV on-screen
menu.
Push and hold the AUTO-TUNING
button for about 1 sec, then the headphone
will automatically search for the best
possible reception.
1) Alter the transmitter's frequency
channel. Select 1 of the 3 options for best
reception.We advise you to select channel
1 as the first option. Next adjust the
headphone's tuning channel as described
above.
2) Move transmitter or headphone
elsewhere
Move closer for reception
Make use of the SHG8100 transmitter
provided. Some transmitters already built
into other equipment may not be compatible
with the SHG8100 receiver unit because of
the advanced technologies used.