Teeter Hang Ups Contour Serie Instrucciones De Ensamblaje página 16

FIGURE 23
FIGURE 24A
Counterclockwise to Loosen,
Clockwise to Tighten.
FIGURE 24B
Counterclockwise to Lock,
Clockwise to Release.
Option: instead of rotating to lock
pins in the "out" position, simply
pull the knobs up, slide, and
release into your desired setting.
Adjustments
Changing the Rotation Adjustment Setting
• Loosen the De-Rattler Knob.
• Shorten the Main Shaft and rotate the Table Bed opposite from use into its storage position.
Leave the A-Frame open and locked at the spreader arms (Figure 23).
• The Pinlock Knobs serve two functions:
- As a "de-rattler" to prevent excess movement of the support arms (Figure 24A)
- As a "spring-loaded pinlock" to engage the Rotation Adjustment Setting (Figure 24B).
• First, loosen the "de-rattler" function of the Pinlock Knobs by rotating them counterclockwise.
Then pull the knobs up to disengage the pin and rotate again counterclockwise to lock them
in the "out" position.
• Move the Support Housing along the Rotation Adjustment Arms to the desired setting using
the line markings as a guide. Rotate the pin clockwise to release the lock and allow the pin to
engage a hole. You will hear a click when the pin is properly engaged.
NOTE: Engage the Pinlock Knobs in the same setting for each of the Rotation
Adjustment Arms.
• Turn the Pinlock Knobs clockwise again to re-engage the De-Rattler.
• Rotate the Table Bed back to its use position and extend the Main Shaft to your
preferred setting.