Teeter Hang Ups Contour Serie Instrucciones De Ensamblaje página 9

FIGURE 3
FIGURE 4
Loosen Tighten
Counterclockwise to Loosen, Clockwise to Tighten
FIGURE 6
FIGURE 5
A
B
C
1
2
1
Support Housing
Rotation Adjustment Arms
2
FIGURE 7
Counterclockwise to
Release
Lock, Clockwise to
Lock
Release
Step
Assemble the Table Bed (NX-1300) to the A-Frame (NX-1100)
• Position the A-Frame on the floor with the crossbar pointing down, so that the frame is resting on
the Rotation Adjustment Arms (Figure 3).
• With the Table Bed face up and the top of the bed pointing to the A-Frame feet, slide it on the
floor between legs of the A-Frame.
• Loosen the "de-rattler" function of the Pinlock Knobs by turning each counterclockwise (Figure 4).
• Align and insert the Rotation Adjustment Arms into the Support Housings (Figure 5).
• Pull out both spring-loaded Pinlock Knobs and then pull up to align the Support Housing with one
of the marked settings on the Rotation Adjustment Arms (Figure 6).
• Release the knobs so that they engage a hole setting (Figure 6). Should the knobs be locked in
the "out" position, simply rotate clockwise to release (Figure 7).
NOTE: Refer to the Owner's Manual for an explanation of the hole settings. If you are unsure,
use Setting C to start.
2