Teeter Hang Ups Contour Serie Instrucciones De Ensamblaje página 8

FIGURE 1
1
2
3
1 Support Beam
Upper Support Arms
2
Rubber Spacers
3
FIGURE 2
Step
Attach the Support Beam to the Table Bed (NX-1300)
• Place the Table Bed face down on the floor. Push down on the Support Beam so that the two
holes align evenly with the holes at the base of the Upper Support Arms (Figure 1).
• Insert the two bolts (EP-1128) into the open holes (Figure 1).
• Fasten each bolt with a washer and nut (Figure 2).
• Use the Allen Wrench (IA-1149) to steady each bolt and tighten the nuts using the 10/13 mm
open end Wrench provided (F5-1088) (Figure 2).
1