Omnitronic CM-742 Manual Del Usuario página 20

order to mix the signal of channel 1 with channel 2.
When the crossfader is set to the center position, both channels can be heard at once.
(16) CROSSFADER
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels
can be heard at the same volume.
(17) MIC 1-SOCKET
You can connect microphones with XLR-plug and control the signals via the Mic Level-control.
(18) TALKOVER-SELECTOR
The TALKOVER-selector has 3 different functions:
OFF: the microphone is switched off.
MIC ON: the microphone is activated.
TALKOVER: the level of all other signal-sources is attenuated by 15 dB, so that the microphone can
clearly be heard.
(19) MIC LEVEL-CONTROL
With the MIC LEVEL-control, you can adjust the microphone volume.
(20) TREBLE-CONTROL
Used to increase or lower the HIs of the microphone signal.
(21) MIDDLE-CONTROL
Used to increase or lower the MIDs of the microphone signal.
(22) BASS-CONTROL
Used to increase or lower the LOWs of the microphone signal.
(23) BALANCE CONTROL
Used to adjust how much of the signal is sent to the left and right MASTER 1-socket.
(24) STEREO/MONO SWITCH
Used to set the master output to mono or stereo. If you connected a mono-signal via 1 RCA-socket, you
can switch the output signal to STEREO in order to have a stereo output signal.
(25) MASTER 1 FADER
Adjusts the level of the master 1 output.
(26) EFFECT-BUTTON
With the EFFECT-button you can switch the Effects-sockets on or off.
(27) MASTER 2 CONTROL
Adjusts the level of the master 2 output.
(28) BOOTH CONTROL
The CM-742 features a DJ BOOTH monitor system. Connect your monitor system with the BOOTH-
sockets on the rearpanel.
(29) CUE LEVEL-FADER
With the CUE LEVEL-fader, you can adjust the phones volume without changing the output signal.
(30) CUE MIXING FADER
Connect your headphones to the HEADPHONES socket. With the CUE-buttons, you can select the
desired channel.
When you set the CUE MIXING-fader to PGM (CUE-buttons without function), you can cue the output
signal of the mixer.
When you set the CUE MIXING-fader to to the center position, you can cue both the channel-signal you
selected and the output-signal.
(31) CUE SPLIT/CUE MIX BUTTON
Cue Split-function (button pressed): the Cue-signal is on the one side of the headphones and the output-
signal on the other side.
Cue Mix-function (button released): the adjustable mix of Cue-signal and output-signal is on both sides
of the headphones.
(32) HEADPHONES SOCKET
Use this socket to connect the headphones. Headphones from 8 Ohms to 600 Ohms can be used. 16
Ohms is recommended.
20