Replacing The Fuse; Technical Specifications - Omnitronic CM-742 Manual Del Usuario

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Please note: This fuse is being used for both 115 V and 230 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

10. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Inputs:
Minimum input voltage:
3 mV RMS, 10 kOhms
Phono:
Line:
Output voltage:
Line:
Headphones:
Outputs:
Master 1 Out:
Frequency range:
Microphone:
Phono:
Line:
Distortion:
S/N-ratio:
Microphone:
Phono:
Line:
Talkover-attenuation:
Tone control:
Treble:
Middle:
Bass:
Dimensions (WxDxH):
Weight:
Fuse:
Please note: Every information is subject to change without prior notice. 03/02 ©
115/230 V AC, 50/60 Hz ~
18 W
3 phono, 4 line, 3 aux, 2 mic
Microphone:
1.2 mV RMS, 47 kOhms
78 mV RMS, 10 kOhms
9 V RMS max.
0.5 V
2 Master-Out, 1 Rec-Out, 1 Booth-Out via RCA; Faderstart
via 2 additional, balanced XLR-connectors
40 - 15,000 Hz, ± 0.5 dB
20 - 20,000 Hz, ± 1 dB
20 - 20,000 Hz, ± 0.5 dB
< 0.01 %
> 80 dB
> 78 dB
> 88 dB
-15 dB
20 Khz -30 dB to +15 dB
1.2 KHz -30 dB to +15 dB
40 Hz -30 dB to +15 dB
482 x 241 x 92 mm
4.8 kg
F 0.5 A, 250 V
23