Operation And Maintenance; For Your Safety; Gas Cylinder - Campingaz Woody L Utilización Y Mantenimiento

NOTE: unless otherwise specified, following generic terms "appliance / unit / product / equipment / device" appeared
in this instruction manual all refer to the product "adeLaide/genesco".
• Please read the instructions carefully before using.
• Use outdoors only
• It is best to wear gloves to assemble the product.
• Do not use charcoal.
GB
• Do not use an adjustable low pressure regulator. Use fixed regulators that comply with the European
standard concerning them.
• To ensure safe operation of your device, never use two full hot plates side by side.
Follow these instructions carefully to avoid seriously damaging your barbecue.
a) FOR yOUR SAFETy
- do not store or use petrol and other flammable liquids or
vapours in the vicinity of this barbecue. this device must
be kept away from inflammable materials when it is in use.
if you smell gas:
1) close the valve of the cylinder
2) extinguish all naked flames
3) open the lid
4) if the smell continues ,see "f checking for gas leaks"
or immediately seek advice from your local retailer.
- Parts which are protected by the manufacturer or the
manufacturer's representative must not be manipulated
by the user.
- close the gas container after use.
b) LOCATION
- this barbecue must only be used outdoors.
- CAUTIOUS: accessible parts may get very hot. keep
young children away.
- there should be no combustible materials within a
radius of approximately 60 cm around the barbecue
- do not move the barbecue when alight.
- the appliance should be operated on a level surface.
- estimated air offtake 2 m
c) GAS CyLINDER
this barbecue has been adjusted to be operate off 4,5 to
15 kg butane/propane cylinders with an appropriate low
pressure regulator.
• Switzerland: see separate sheet.
• France, Belgium, Luxembourg, United Kingdom,
Ireland, Portugal, Spain, Italy, Greece: butane 28-30
mbar / propane 37 mbar.
• Netherlands, Czech Republic, Slovakia, Hungary,
Slovenia, Norway, Sweden, Denmark, Finland,
Bulgaria, Turkey, Romania, Croatia: butane 30 mbar
/ propane 30 mbar.
• Germany, Austria: butane 50 mbar / propane 50 mbar.
• Poland: propane 37 mbar.
• always connect or replace the cylinder in a well-
ventilated area, never in the presence of a flame, spark
or heat source
The gas cylinder equipped with the regulator should
not be put under the barbecue if its total height
exceeds 46.5 cm.
When the gas cylinder is put under the barbecue, it
must be attached to the frame of the barbecue using the
supplied strap.
d) Hose
France (depending on model)
The equipment may be used with two types of flexible hose:
a) flexible hose designed to be joined onto ringed
tailpieces on both the barbecue and regulator sides,
held firm with collars (in accordance with standard XP d
36-110). Recommended length 1.25 m.
g 1/2
barbecue

Operation and maintenance

/kW/h.
3
M 20x1,5
Regulator
b) flexible hose (according to standard XP d 36-112 or nF
d 36-112) fitted with a g 1/2 threaded nut for fixing to
the barbecue and a M 20x1.5 threaded nut for fixing to
the regulator, recommended length 1.25 m.
g 1/2
barbecue
The barbecue has a G 1/2 threaded gas inlet connector
supplied with pre-fitted NF ringed tailpiece and seal.
1) To use the equipment with the flexible hose XP D
36-110: (solution d) a))
- slide the flexible hose onto the ringed tailpiece on both
the barbecue and regulator as far as it will go.
- slide the collars behind the two first bosses on the
tailpieces and tighten them until the tightening head
breaks.
- check for leaks following the instructions in paragraph f).
2) To use the equipment with the flexible hose XP D
36-112 or NF D 36-112, G 1/2 and M 20x1.5 nuts:
(solution d) b))
- loosen and remove the nF ringed tailpiece to release
the g 1/2 inlet connector.
- remove the seal
- tighten the g 1/2 threaded nut on the hose onto the
barbecue inlet connector and the M20x1.5 threaded
nut onto the regulator output connector following the
instructions supplied with the flexible hose.
- use a spanner to hold the barbecue inlet connector firm
and tighten or loosen the threaded nut with another
spanner.
- use a spanner to hold the regulator outlet connector
firm.
- check for leaks following the instructions in paragraph f).
check that the flexible hose stretches out normally
without twisting or pulling and does not come into contact
with the hot sides of the barbecue. it should be replaced
when the expiry date on the hose is passed or whenever
it is damaged or develops surface cracks.
6
M 20x1,5
Regulator
black