Prior To Use; Checking For Gas Leaks - Campingaz Woody L Utilización Y Mantenimiento

Belgium, Luxembourg, United Kingdom, Ireland,
Portugal, Spain, Italy, Croatia, Greece, Netherlands,
Czech Republic, Slovakia,
Norway, Sweden, Denmark, Finland, Bulgaria,Turkey,
Romania, Poland, Switzerland (depending on model) :
the barbecue is equipped with a circular connector. it
should be used with flexible hose that is suitable for use
with butane and propane gas. Hose length should not
exceed 1.20 metre. it should be replaced if it is damaged
or cracked, when required by national regulations or at the
end of the part lifecycle. do not pull or pierce the hose.
keep away from any parts of the barbecue that get hot.
check that the flexible hose stretches out normally,
without twisting or pulling.
Germany,Austria Switzerland (depending on model):
the barbecue should be used with flexible tubing that
is suitable for use with butane and propane gas. Hose
length should not exceed 1.50 metre. it should be
replaced if it is damaged or cracked, when required by
national regulations or at the end of the part lifecycle. do
not pull or pierce the tubing. keep away from any parts
of the barbecue that get hot. check that the flexible hose
stretches out normally, without twisting or pulling.
Flexible tubing connection: to connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
provided:
- no. 14 wrench to tighten the connector
- no. 17 wrench to tighten the nut on the tubing
e) LID (DEPENDING ON MODEL)
Handle the lid carefully, especially during operation. do not
lean over the base.
f) CHECKING FOR GAS LEAKS
1) Work outside, away from all sources of ignition. do not
smoke.
2) Make sure the control knobs are in the "off" (●) position.
connect the flexible tubing to the connector and
3)
barbecue as described in part d).
4) Fit the regulator onto the gas cylinder in accordance with
its instructions.
5) use a gas leak solution to test for leaks. Important: never
use a naked flame to check for gas leaks.
6) apply the solution to the connections cylinder/regulator/
hose/apparatus (the control knobs should remain closed:
off position (●)). open the gas cylinder valve.
7) Bubbles in the gas leak solution indicate that there are gas
Hungary, Slovenia,
8) the leak can be stopped by tightening any hose connection
9) close the valve on the gas cylinder.
Important:
check for leaks at least once per year and each time the gas
cylinder is replaced.
g) PRIOR TO USE
never use the barbecue until the instructions have been read
carefully and understood. also, make certain that:
- there are no leaks
- the venturi tubes are not blocked (example: spider webs)
- the hose does not touch any components which may get
hot.
- that the ventilation openings in the gas receptacle housing
are not obstructed, if appropriate.
- that the drippings tray has been properly inserted in the
tray housing and that it has been pushed all the way
back until it will not go in any further.
h) LIGHTING THE BARBECUE BURNERS
- Remove the protective cover or open the cooking area
lid (depending on model).
- Make sure that the control knobs are in the "oFF"
position (●).
- Push an adjustment button down and turn it anti-
clockwise until it is in the full flow position
immediately press the ignition button down ( ) until you
hear a click. Repeat 3 or 4 times if necessary.
- Repeat this operation until the burner lights.
- if the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
once the burner is lit, there are two ways of lighting
another burner:
□ Firstly, repeat the lighting operation described above;
□ secondly, light the burner to the right or left of the first
if the piezoelectric ignition does not function, light the burners
manually (next paragraph).
i) LIGHTING THE BARBECUE MANUALLy
- Remove the protective cover or open the cooking area
lid (depending on model).
- Make sure that the control knobs are in the "oFF"
position (●).
- Remove the grease drip tray.
- strike a match and bring it close to the burner from
below.
- Push an adjustment button down and turn it anti-
7
leaks.
or replacing any faulty component. the barbecue must not
be used until the leak is stopped.
Check that the venturi tubes (VT) cover the
injectors (IJ).
burner lit, then the other burners in turn by turning the
adjustment button to the full flow position
GB
( ) , then
.
( )