GE Baker Hughes PACE CM Instrucciones De Seguridad Y Guía Del Usuario página 9

Note: For instruments with NPT connections, use applicable bonded sealing as shown in
Figure 1.
1 Connector
1. Installation
The pneumatic control module requires a positive pressure supply. Pneumatic control
modules operating in an absolute range or negative pressure range require a vacuum supply.
A vacuum supply should be used for a fast response for pneumatic control modules operating
near atmospheric pressure.
Control/measure
sensor
Vacuum sensor
Pressure sensor
Figure 2: PACE CM Pressure Manifold Pneumatic Diagram
© 2008 Baker Hughes, a GE company – All rights reserved.
2
1
2
Figure 1: Pneumatic Connections
PACE CM
Pressure Manifold
Bonded seal
Vent port
Output port
Supply - port
Supply + port
PACE CM Safety Instructions and User Guide-English | 5