GYS 061385 Manual De Instrucciones página 10

Translation of the original instructions
7
8
9
10
1
11
12
10
MANUAL WHEEL LIFT
1
1
2
1
2
1
1
1- Position the pulley on the pulley support, and fix it with
an M8 screw and the M10 flat washer.
1- Attach the cap to the column with 3 M8 screws
1- Pass the cable around the pulley and bring it out
through the light of the cap.
2- Secure the pulley bracket with an M8 screw.
1- Remove the flange (grey plastic part) by unscrewing the
2 screws that hold it to the winch using a cross-head
screwdriver.
2- Secure the winch to the column using 2 M8 screws.
3- Screw the flanges back on.
1- Secure the cable by passing the M8 screw through the
cable loop. Tighten with the M8 nut.
Do not use the cable fixing system on the winch composed of a bolt
and a plate. Remove it by unscrewing it.
1- Attach the bolt box to the column with an M8 screw
(bend the fixing bracket).
EN
Screw M8 : 1
Flat washer M10 : 1
Screw M8 : 3
Screw M8 : 1
Screw M8 : 2
Screw M8 : 1
Nut M8 : 1
Screw M8 : 1