Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand Q60P3 Especificaciones Del Producto

Product Safety Information

Intended Use:
These tools are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04584983.
Manuals can be downloaded from ingersollrandproducts.com

Product Specifications

Model(s) Style
Type
Q60P3 Pistol Square
Q60PQ1 Pistol Insert Bit 3/8
Q70P3 Pistol Square
Q70PQ1 Pistol Insert Bit 1/4
Q80P3 Pistol Square
Q80PQ1 Pistol Insert Bit 1/4
Q90P3 Pistol Square
Q110P4 Pistol Square
Q120P4 Pistol Square
Q140P4 Pistol Square
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K= Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16585747 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
After each 20,000 cycles, or as experience indicates, drain and refill the Impulse Unit Drive
Assembly using the Fluid Replacement Kit (Part No. EQ106S-K400). Lubricate the hex drive and
the output shaft before assembly.
80206667_ed7
Free
Drive
Speed
Size rpm † Pressure (L
1/4 4000
4000
3/8 7000
7000
3/8 7000
7000
3/8 6500
1/2 5500
1/2 6600
1/2 5400
WARNING
Sound Level dB(A)
(ISO15744)
) ‡ Power (L
p
72.4 ---
72.4 ---
79.3 ---
79.3 ---
80.8 91.8
80.8 91.8
78.3 ---
84.4 95.4
81.0 92.0
85.0 96.0
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
EN
Vibration m/s²
(ISO28927)
) Level *K
w
<2.5 ---
<2.5 ---
3.5 1.2
3.5 1.2
3.7 1.0
3.7 1.0
4.6 0.9
5.4 0.9
4.6 0.9
6.7 1.1
EN-1