Black and Decker GW3031BP Manual De Instrucciones página 8

ENGLISH
consider, the actual conditions of use and
the way the tool is used, including tak-
ing account of all parts of the operating
cycle such as the times when the tool is
switched off and when it is running idle in
addition to the trigger time.
Labels on Appliance
The following pictograms, along with the
date code, are shown on the tool.
Warning! Read the manual prior
to operation.
Wear safety glasses or goggles
when operating this appliance.
Wear suitable ear protection
when operating this appliance.
Do not expose the tool to rain or
high humidity or leave outdoors
while it is raining.
Switch off: remove plug from
mains before cleaning or mainte-
nance.
Disconnect the mains plug if
the cord becomes damaged or
entangled.
Beware of flying objects.
Keep bystanders away.
Directive 2000/14/EC guaran-
teed sound power.
Features
This appliance includes some or all of the following features.
1. Variable speed control
2. Cable restraint
3. Back pack collection bag
4. Upper blow tube
5. Lower blow tube
6. Upper vacuum tube with fixed handle
7. Middle vacuum tube
8. Lower vacuum tube
9. Vac release button
8
(Original instructions)
10. Bag release button
11. Powerhead
12. Back pack hose connector
Using your product
Warning! When using as a blower or vacuum, always wear
safety glasses. If using in dusty conditions, wear a filter mask
as well.
Warning! Switch off your product, allow the fan to stop and
remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Assembly
Warning! Before assembly, make sure that the
appliance is switched off and unplugged.
Warning! Always wear protective gloves when
working with your blow vac.
Vacuum tube assembly (fig. A)
The vacuum tubes must be assembled together before use.
Warning! Do not operate the appliance with the vacuum tubes
separated.
To ease assembly, apply a soapy water solution to the
u
joint area.
Align the notches (13) and the triangles (14) on the upper
u
(6) and middle (7) vacuum tubes.
Push the upper vacuum tube (6) firmly onto the middle
u
vacuum tube (7) until the triangles click into place.
Align the notches (13) and the triangles (14) on the middle
u
(7) and lower (8) vacuum tubes.
Push the middle vacuum tube (7) firmly onto the lower
u
vacuum tube (8) until the triangles click into place.
Warning! Do not separate the tubes once assembled.
Vacuum mode (fig. B, C, D, E, F, G, H, I, J)
Note: For vacuuming/shredding, the back pack collection bag
(3) must be fitted.
Remove the fan cover (22) by pressing the vac release
u
button (9) and pulling the fan cover (22) off.
Ensuring that the fan cover does not fall to the ground.
Attach the back pack collection bag (3) to the vacuum
u
outlet (25) by pressing it firmly on till it clicks into place.
Attach the assembled vacumm tube to the powerhead (11)
u
by locating the assembly as indicated by the arrow, then
pivot about this point and press the vac release button (9)
until the catch is fully engaged.
Place the straps from the back pack collection bag over
u
your shoulders (fig. D) this will support the additional
weight as the back pack collection bag fills.
Position the vacuum tube slightly above the debris/leaves.
u
Switch on the appliance by turning the variable speed con-
trol (1) clockwise to the required setting (fig.F) and use a