Environmental Information - Flymo Lawnrake Instrucciones Originales

the entire product is in a safe operating condition.;
- if the product starts to vibrate abnormally. Check
immediately. Excessive vibration can cause injury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
• Do not use in wet or damp conditions. Raking in wet
conditions can damage the lawn.
• Do not force the lawnrake through long grass it
should be used on grass no longer than 75mm in
length.
• Clear the lawn of any loose debris or stones that
Removing and Fitting the Tines
1. Ensure plug is removed from power supply
2. Turn the lawn rake upside down to access the tines
3. Remove the screw from the central disc on the set of
tines you wish to replace (L)
• Awareness of the environment must be considered
when disposing of ʻend-of-lifeʼ product.
• If necessary, contact your local authority for disposal
information.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical
and electronic equipment.
• Your product is uniquely identified by a silver and black product rating label.
• We strongly recommend that your product is serviced at least every twelve months, more often in a professional application.
If any part is found to be defective due to faulty
manufacture within the guarantee period, Husqvarna
UK Ltd., through its Authorised Service Repairers will
effect the repair or replacement to the customer free of
charge providing:
(a) The fault is reported directly to the Authorised
Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or faulty
adjustment by the user.
(d) The failure has not occurred through fair wear and
tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna UK Ltd..
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Safety
Removing and fitting the Tines

Environmental Information

Service Recomendations
Guarantee and Guarantee Policy
ENGLISH - 2
2. Check the collection box frequently for wear or deterioration.
3. Replace worn or damaged parts for safety.
4. Only use the replacement parts specified for this product.
5. Be careful during adjustment of the product to
prevent entrapment of the fingers between moving
and fixed parts of the machine.
Use
may damage the lawnrake.
• On your first use choose a medium height to start
with, and then adjust the height setting to suit your
lawn and use.
• To maintain the quality of your lawnrake it is
recommended that you clean it after use.
4. Rotate the central disc to unlock the tines (M)
5. Remove the existing tine and replace with a new
one.
6. Fitting is reversal of removal.
By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for
the environment and human health, which could
otherwise be caused by inappropriate waste handling of
this product.
For more detailed information about recycling of this
product, please contact your local council office, your
household waste disposal service or the shop where
you purchased the product.
Failures due to the following are not covered, therefore
it is important that you read the instructions contained in
this Operator's Manual and understand how to operate
and maintain your machine:
Failures not covered by guarantee
* Replacing worn or damaged tines.
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and recommendations
contained in this Operator's Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as wearing
parts and their life is dependent on regular
maintenance and are, therefore not normally subject to
a valid warranty claim: Tines, Electric Mains cable.
* Caution!
Husqvarna UK Ltd. does not accept liability under
the warranty for defects caused in whole or part,
directly or indirectly by the fitting of replacement
parts or additional parts that are not either
manufactured or approved by Husqvarna UK Ltd.,
or by the machine having been modified in any way.