Assembly Instructions - Troy-Bilt TB154 Manual De Instrucciones

Ocultar thumbs Ver también para TB154:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLING THE HANDLEBARS
Before you can operate the unit, you must install the
handlebars.
1.
When you unpack the unit, hold the handle bar in the
position shown in Figure 1 and slide it onto the lower bars.
2.
Align the holes in the handlebar with the holes in the lower
bars and insert the bolts through those holes.
3.
Hold the handle in place while screwing the knobs onto
the bolts (Fig. 2).
4.
Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
5.
Check to make sure the bail is assembled into the switch
assembly (Fig. 1, Inset A).
NOTE: Take care not to pinch the switch cable when
positioning the handlebars.
6.
Clip the switch cable to the cable restraint on the lower
bar as shown in Figure 1, Inset B.

ASSEMBLY INSTRUCTIONS

Fig. 1
Fig. 2
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido