Troubleshooting Hints - Metz SCA 3302 M7 Manual De Instrucciones

after the last setting was made (Auto-Off function).
When automatically switched off, the mecablitz is
in a standby state.
As soon as the camera's shutter release is touched,
the SCA 3302 adapter will "wake up" the mecablitz
and switch it on again (wake-up function).

5. Troubleshooting hints

Should, for example, the LC display of your meca-
blitz indicate meaningless information or should
the flash unit not function properly you can try to
overcome this problem as follows:
1a) Switch off the flash unit by its main switch.
1b) Remove the batteries.
1c) Switch on the flash unit for about 1 second and
then switch it off again.
1d) Re-insert the batteries.
or / and:
2a) Switch off both the camera and the mecablitz.
2b) Remove the SCA adapter from the mecablitz
and then remount it.
The mecablitz should operate properly when it is
switched on again. Contact your local dealer
should this not be the case.
For the latest news and information, please
visit the Metz homepage in the Internet at
www.metz.de
50