Finish.mounting; Specifications - Heath Zenith JourneyMan Serie Manual De Instrucciones

Finish Mounting
❒
Align the JourneyMan
and the mounting bracket hole. Secure with
M5 x 0.8 x 40 mm mounting screw supplied.
❒
Push the rubber plug firmly into place.
❒
If not installed on a weatherproof box, caulk
between the cover plate and mounting sur-
face with silicone weather sealant.
cover plate, gasket,
®
To obtain maximum lamp
life, keep the tubular
lamps horizontal.
Rubber Plug
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the fixture
operate at high temperatures.
• Keep fixture at least 3" (76 mm) from combustible materials.
Do not aim at objects closer than 3' (1 m).
• Use only type T 250W (max.) tungsten halogen 120 VAC
lamps.

Specifications

Range .......................... 70 feet (21.0 m); 100
Sensing Angle ............. Up to 270° (Adjustable)
Fixture Load . ............... Up to 500 W atts Maximum
Sensor Load Capacity . Up to 1000 Watts (8.3
Power Requirements ... 120 VAC, 60 Hz
Operating Modes . ........ TEST, AUTO, and MAN-
Time Delay . ................. 1, 5, 20 minutes
HeathCo LLC reserves the right to discontinue
products and to change specifications at any time
without incurring any obligation to incorporate
new features in products previously sold.
-8-
feet (30.5 m) with Range
Boost. Varies with sur-
rounding temperature.
Tungsten Incandescent
[Up to 250 Watts maxi-
mum each lamp holder.]
amps), Maximum Tung-
sten Incandescent
UAL OVERRIDE
598-1188-02