Tape Playback; Basic Operations - Aiwa NSX-AJ22 Manual De Instrucciones

TAPE PLAYBACK

BASIC OPERATIONS

This unit is designed for optimal playback of Type I
(normal) tapes.
1 Press TAPE and press z PUSH EJECT to open
the cassette holder.
Insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press c to start play.
Only the side facing out from the unit can be played back.
Selected deck number
12
ENGLISH
Tape counter
To select a playing deck
When tapes are loaded in both decks, press TAPE first to select
a deck.
The selected deck number is displayed.
To stop play, press s.
To pause play (deck 2 only), press a. To resume play, press
again.
To fast forward or rewind, press f or g. Then press s to
stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE. The power is turned on and play of the inserted
tape begins.
To set the tape counter to 0000
Press s CLEAR in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
When tapes are loaded in both decks
After playback on deck 1 finishes, the tape in the deck 2 will start
to play without interruption and will stop at the end of the tape.
(Continuous play)
Type II (High position) tapes can also be played back in
this unit. When playing back a Type II tape, turn MULTI JOG
to display "SOFT" in the display. This will set the
optimum playback sound for Type II tapes. However,
"SOFT" playback will be canceled if any graphic equalizer
is selected (page 8), the unit is switched to a different
audio source, the cassette holder is open, or when the power
is turned off.