TEFAL Powermix 500 W HT6111 Manual De Instrucciones página 86

• Connect the appliance:
- Your appliance has 5 speed levels
and a turbo button. Always begin
mixing or kneading at speed 1
initially, then move to speed 2, 3, 4
or 5 (fig. 2).
- To knead thick dough, we
recommend using speed 5 only.
- You can also increase the speed by
pressing the turbo button (a2);
We however recommend that you
use it only briefly (a maximum of 30
seconds for thick dough).
• After finishing, set the speed control
(a2) to "0".
• Disconnect and press the unlock
button (i) to raise the hinged arm.
Then press the mixer unlock button (j)
to remove the mixer from its stand.
• Then press the ejection button (a1) to
remove the beaters or kneaders.
BlenDer funCtion
(DepenDing on MoDel)
• Check that the appliance is
unplugged, that the speed control
(a2) is set to "0" and that the beaters
or kneaders have been removed
from the appliance.
• Lift the panel at the back of the
appliance and screw the blender
shaft (l or m) anti-clockwise without
forcing it until you hear a click (fig.
6).
if you feel resistance when screwing
in, this means that shaft is not
correctly aligned.
You should remove it completely and
screw it in again correctly.
• Connect the appliance:
- Dip the blender shaft into the
preparation before starting the
appliance to avoid splashing.
- Start using the speed control (a2),
(fig. 2), initially at speed 1 then 2, 3,
4, 5. Use the Turbo button (a2) if the
recipe requires more power.
- Stop the appliance before
removing the blender shaft from the
preparation (to avoid splashing).
removing the blender shaft:
• Stop the appliance by selecting
"0", disconnect it and unscrew the
blender shaft (l or m) by turning
clockwise.
Do not use the blender shaft:
• In a container on a heat source.
• Do not use it empty or with ice
cubes, to chop raw meat, dried fruit
(almonds, hazelnuts, etc.).
500Ml Mini-Chopper
funCtion
(DepenDing on MoDel)
- Place the bowl (n1) on the stabiliser
base (q).
- Fit the blade (n2) on the shaft of the
bowl (n1).
- Place the food in the bowl (n1) and
then fit the reducer (n3).
• Check that the appliance is
unplugged, that the speed control
(a2) is set to "0" and that the beaters
or kneaders are no longer on the
appliance.
- Lift the panel at the back of the
appliance and place the appliance
on the reducer (n3) of the mini-
86