Technical Data - BURG-WACHTER FireProtec FP 43 E Manual Del Usuario

User manual
Structure
Important notes
Bolts
Reset-Button
Knob (Master Key)
Battery cover
Start button
Dear customer,
Thank you for deciding for the FireProtec FP 43 E safe manufactured by
BURG-WÄCHTER. Beside the electronic lock, this safe has an integrated
mechanical emergency lock mechanism.
Important: Please read the entire User Manual before you start programming.
We hope you enjoy your new safe system.
Your BURG-WÄCHTER KG
Please take care that the codes and the code carrier. Do not fall into the wrong
hands. Therefore, store the codes and code. Carrier at a safe location so that
these can only be accessed by authorised persons. In case you loose a code or
code carrier, the lock must be
converted to a new code / code carrier, or replaced.
• The factory code must be changed as soon as the lock is commissioned.
• Simple codes that are easy to guess (e. g. 1, 2, 3, 4, 5, 6) must not be used.
• Personal data (e. g. birthday) or other data that may be concluded with
knowledge of the code owner must not be used as code.
• After changing the code, the lock must be checked several times with the
safety door opened.
Attention: Any changes of the administrator code and of the user codes shall
be made with the safe door opened! When the locking system has been reset
to another code, this new code should be repeatedly used with the safe door
opened.
BURG-WÄCHTER KG Altenhofer Weg 15 58300 Wetter
• •
en
Illustrations
F e u e r s c h u t z t r e s o r

Technical data

Initial setup
Opening with user code
Programming of user code
Blocking times
Power supply
Permissible ambient conditions
(lock)
#2007-0881 CNCF
Measured in-cabin-temperature:
• Upon first receipt open with standard code 1-2-3-4-5-6 or if lost key, open
the door with the emergency key. In order to do that, remove the battery
cover, insert the emergency key and turn it counter clockwise
• Turn the knob clockwise
• Open the door
• Remove the emergency key and store it in a safe place.
• Insert the batteries.
• Set the user code
• Press the „Start button", the display shows „----"
• Input your user code. If correct the lock will unlock and the green LED
will light up.
• Turn the knob clockwise
• Open the door
• With the door open press the „Start button", the display shows „----"
• Input the new 6 digit code
• Press the „Reset button"
• The display shows „USER-IN" to indicate the successful programming
of the user code
Germany www.burg.biz
• •
FireProtec
Certified protection against fire
FP 43 E
Programming of general code
Closing the door
Battery change
Guarantee
Disposal
• With the door open press the „Reset button", the display shows „----"
• Press the „Start button"
• Input the new 6 digit code
• The display shows „SUPER-IN" to indicate the successful programming
• Close the door
• Turn the knob counter clockwise
• Remove the battery cover
After 3 wrong code entries for
3 minutes • Take out the old batteries
• Insert four new batteries with correct alignment
4 x MIGNON LR6 / AA / ALKALINE
–15°C to + 50°C If the battery voltage is too low, "Lo Batt" appears on the display.
All four batteries need to be replaced in such case. If an outage occurs for
up to 95 % rel. air humidity
(noncondensing) more than 30 minutes you should reset and reprogramm the user code.
1 hour by max 1.030° C
< 160° C BURG-WÄCHTER products comply with the technical standards in force at the
time of production and adhere to our own quality standards.
The guarantee only covers defects which can be proved to have resulted from
production or material defects at the time of purchase. The guarantee expires
after two years; further claims are excluded.
the device returned to the place it was bought, together with the original
packaging. After the device has been tested, and within an appropriate period
of time, the guarantor will decide whether or not to repair or exchange the
item.
Any defects or damage which may have resulted from transport, inappropriate
or improper use, wear and tear etc. are not included in the guarantee.
The battery is not included in the guarantee
Dear Customer,
Please help us avoid unnecessary waste. Should you intend to dispose of this
device at any time, please remember that many components of this device
contain valuable materials, which can be recycled.
A short description of any defects identified must be made in writing and
of the general code
Please be aware that electrical and electronic equipment and batteries
shall not be disposed of as household waste, but rather collected
separately. Please obtain information on the collecting points for
electrical waste from the responsible authority of you municipality.
BURG-WÄCHTER KG hereby declares that this device complies with
Directive 2014/30/EU, (EMC) 2011/65/EU (RoHS)
and (2014/35/EU).
The full text of the EU Declaration of Conformity can be found on
www.burg.biz.
Subject to technical changes without notice. Errors excepted.
FireProtec FP43 E | ENGLISH