Using Your Ed Tv; Selecting The Tv Signal Source - Insignia IS-EDPLTV42 Guia Del Usuario

3 Enter the three-digit code for the device. The LED blinks each time
you enter a number.
4 Press the device key again. The activity indicator should flash,
then turn off to indicate that the code is accepted.
Note

Using your ED TV

Turning your ED TV on and off
To turn your ED TV on and off:
1 Plug the power cable into an electrical outlet.
Warning
2 Press the POWER button on the remote control or front of your
ED TV to turn your TV on or off.

Selecting the TV signal source

To select the TV signal source:
1 Press the Menu button to open the OSD.
2 Press the VOL + or VOL – button to select PRESET.
3 Press the CH + or CH – button to select RF INPUT.
4 Press the VOL + or VOL – to select one of the following:
•
•
•
•
Setting the video source
To set the video source:
1 To select TV, press the CH + or CH – button or use the number
buttons to enter a channel number.
2 To select the device connected to the Video 1 or Video 2 jacks,
press the VIDEO button once or twice.
18
If you don't press any key on your remote for 10 seconds, the
programming process will stop automatically and you will have to
start over.
Your ED TV is equipped with a polarized alternating-current line
plug (a plug having one blade wider than the other). This plug will fit
into the power outlet only one way. This is a safety feature. If you
are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug still does not fit, contact your electrician to replace
your obsolete outlet.
To prevent electric shock, do not use the polarized plug with an
extension cord or other outlet unless the blades can be fully
inserted.
Air
CATV (STD)
CATV (HRC)
CATV (IRC)
www.insignia-products.com
IS-EDPLTV42 42-inch ED TV