Troubleshooting Guide; Cleaning The Water Tank - TaoTronics TT-AH003 Manual Del Usuario

- Do not power on the humidi er when the water tank is not in place.
- Never add water hotter than 40°C / 104°F to avoid any possible damage or
malfunction of the device.
- Do not pour water through the mist nozzle. Wipe off any water outside the body
with dry cloth.
- When the room temperature is 0°C / 32°F or below, please empty water from the
unit, as ice will damage the components.
- Do not place metals, chemicals, essential oils, or detergents into the water to
avoid any possible damage or malfunction of the device.
- When the water tank is full, do not move it as the water might over ow or ow
into the body and cause damage.
- Do not add water through the nozzle directly under the tap.
- After each use, turn off the unit and unplug the power outlet.
- Do not pour water into the water tank when the power is on or when the
power adapter is plugged in.
- When the water tank is full, the unit can work for 7-12 hours continuously
without needing a re ll.

Cleaning the Water Tank

Before cleaning, make sure the unit is turned off and the power adapter
is disconnected.
• Cleaning the water tank regularly (recommended once every 2-3 weeks):
Remove the water tank plug, wipe off the lime scale,and rinse with clean water.
• Cleaning the base (recommended once a week): Wipe the base with a soft
cloth dipped with a mild cleaning agent and rinse off with clean water.
• Cleaning the humidi er: Rinse a soft cloth in warm water and wipe off surface
stains. You can rinse the nozzle under tap water directly.
• Storing the humidi er: When the unit has not been used for a long time, clean
and dry the unit and store it in a dry place in the original package.

Troubleshooting Guide

Problem Causes
No power source
Power not turned on
Low water
No mist
coming out
The device is getting too hot
Abnormal water pressure
Water exceeds max level
Stain built up inside
Abnormal mist
water tank
Air inlet blocked by dust
Cover not properly covered
Water leakage
Temperature and humidity
of environment is too high
Unit is new
Bad/
strange smell
Dirty water
Mist or drops of
High mist output
water form
around the
Contaminated water
device
Solutions
Connect power adapter
Tap the Power Button to
turn on the humidi er
Add water into the water tank
Power off and place in
a well ventilated place
for 10 minutes
Clear the remaining
water in the base each
time after use
Get rid of some water
Clean the water tank
as instructed
Clean air inlet
Cap on the cover properly
Move the unit to a well
ventilated area
Clean water tank as
instructed, use after air drying
Clean water tank as
instructed, use clean water
Adjust the mist output to low
Use clean water
07/08