Troubleshooting Guide - TaoTronics TT-AH001 Manual De Usuario

Trouble Shooting Guide
Problem Possible Causes
No power supply
LED display is off
Forgot to press ON button Switch on
No water in water tank
LED display is on, but
no mist or wind
Too much water in the
water sink
LED display and the
Mist output is set to the
wind are on but no
lowest level
mist
LED display is on and
the water tank has
Floater is jammed
water, but it shows
there is no water
New unit
Bad smell
Dirty water or the water
has extended its storage
period.
Solution
Connect power supply
Fill water into water
tank
Remove some water
from the water sink
and close the cover of
water tank tightly.
Adjust the mist output
Stir the floater to keep
it flowing smoothly
Take out water tank,
open cover. Put it in
the room without any
operation for at least
half an hour
Clean water tank, fill in
clean water
Water scale on the
transducer
Dirty water or the water
The mist output is
has extended its storage
too small
period
The water is too cold
Lack of water
Strange noise
Placed on an unstable
surface
Water doesn't go
Blocked by filter
down to the sink
Gap between the water
Mist overflows from
tank and the base or gap
the tank or around
between the nozzle and
the nozzle
the tank
Display shows
Current humidity level is
blinking digital
lower than 30%
30% RH
Poor contact for humidity
Display shows Sd sensing element
(Sensor defect)
Sensor damaged
Clean the transducer
Clean water tank,
change to fresh and
clean water
Add some warm water
inside
Fill water tank with
water
Move the unit to a
stable flat surface
Clean the filter
Put some water
around the surface of
the water sink;
Wet the nozzle before
using
Just keep it on
Reinstall it
Replace it
07/08