GYS GYSTART 12.24T Manual Del Usuario página 8

Translation of the original instructions
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting the
device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on the
car frame, far from the battery and the fuel line. The battery charger
must be connected to the power supply network.
• After the charging process, disconnect the battery charger from the
power supply network and remove the connector from the car frame
and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply
• This machine is fuse-protected
• Connection to the mains must be made according to the national
installation regulations.
• This equipment is intended for industrial environments (class A) and
not for residential sites where the electric current is supplied by the
public low-voltage power supply network. There may be potential
difficulties in ensuring electromagnetic compatibility on these sites,
because of the conducted interferences, as well as radiated radioe-
lectrical frequency.
• This product does not comply with IEC 61000-3-12 and is intended
to be connected to private low voltage networks which are connec-
ted to public supply network only at the medium and high voltage
level. If connected to a public low-voltage supply network, it is the
responsibility of the installer or user of the equipment to ensure, by
consulting the operator of the electrical distribution network, that the
hardware can be connected.
Maintenance:
• If the power supply cable is damaged, it must only be replaced by
a cable specified or supplied by the manufacturer or its after-sales
service.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket be-
fore carrying out any work on the device.
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive cleaning
agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
8
GYSTART 12.24T EN