Noise/Vibration Information - Berner BACD BL 12 V Manual Original

OBJ_BUCH-3427-001.book Page 15 Wednesday, October 11, 2017 4:00 PM

Noise/Vibration Information

The measured values of the machine are listed in
the table on page 177.
Sound emission values determined according to
EN 60745-2-2.
Vibration total values a (triax vector sum) and un-
h
certainty K determined according to EN 60745-2-2.
The vibration level given in this information sheet
has been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The in-
structions for each action objective are shown aside. Depending on the type of application, various in-
struction combinations are required. Observe the safety instructions.
Action
Removing the battery
Inserting the battery
Mounting application tools
Reversing the rotational direction
1 609 92A 44E • 11.10.17
tool is used for different applications, with different
accessories or insertion tools or is poorly main-
tained, the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not ac-
tually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Figure Please
observe
1
2
3
4
Page
178
178
178
179
English | 15