Intended Use - Hazet 9048 P-1 Instrucciones

1. Owner's
liability
• The tool was developed and manufactured
according to the technical norms and stan-
dards valid and recognised at the time and
is considered to be operationally reliable.
Nevertheless, the device may present a
danger when it is used in an incorrect or
inappropriate way or by non-qualified per-
sonnel. Please make sure that any person
using this tool or carrying out maintenance
work carefully reads and fully understands
these operating instructions before using
the tool.
• Any modification of the tool is strictly for-
bidden.
• All safety, warning and operating instruc-
tions on the device must be kept legible
at all times. All damaged labels or stickers
must be replaced immediately.
• All specified set values or ranges must be
observed.
• Always keep the operating instructions
close to the device.
• The tool must only be used if it is in good
working condition.
• All safety equipment must always be within
easy reach and should be checked regular-
ly.
12
2
For your safety
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de

2. Intended Use

Operational reliability is only guaran-
teed if the tool is used as intended in
accordance with the information in the ope-
rating instructions. In addition to the safety
advice in these operating instructions, the
general safety regulations, regulations for the
prevention of accidents and regulations for
environmental protection valid for this tool's
application range must be observed and
respected.
Use and maintenance of the tool must always
comply with relevant local and national regu-
lations.
• Ensure optimum use of the cooling system
with the HAZET cooling system cleaner.
• Engine coolant decomposes over time and
in all probability leads to contamination with
abrasion particles and foreign bodies.
• Prevent this by rinsing the cooling system
occasionally and by replacing parts of the
cooling system. The HAZET cooling system
cleaner functions without the use of sol-
vents or aggressive chemicals.
• HAZET cooling system cleaner combines
water with compressed air to increase per-
formance. The compressed air increases
the water pressure in relation to water that
comes from the water mains.
• HAZET cooling system cleaner is equipped
with a ½" / ø13 mm connection for water
couplings. We recommend the use of a
hose connection with a control valve. This
saves you a walk to the tap to control or
shut off the flow of water.
• Place the stepped pistol nozzle of the
HAZET cooling system cleaner in a hose
that is suitable for the flushing task and
flush the system until the outflow from the
radiator / engine block / heater core is clear.
While water flows through the system, blow
short, intermittent blasts of air to increase
effectiveness. To avoid damage, the pas-
sage through the cooling system must be
clear before commencing flushing.
• Incorrect use of the HAZET cooling system
cleaner or use that fails to comply with the
safety instructions can result in serious
injury or death.