Promise Technology SuperTrak EX8300 Guia De Incio Rapido página 4

SuperTrak EX8300, EX8350 Quick Start Guide
Step 2: Install the SuperTrak EX8300 Card
The SuperTrak EX8300 card fits into any available 3.3-volt PCI-X slot. You
cannot plug the SuperTrak card into a 5-volt PCI slot.
1. Remove the cover of your system.
2. Remove the inside slot cover of an available PCI-X slot on the motherboard.
3. Install the SuperTrak card into the open slot (above).
4. Fasten the SuperTrak card bracket to the system case (above).
5. Attach your system case's 2- or 4-pin LED cable to the LED connector on the
SuperTrak card (see page 7).
The SuperTrak EX8300 and EX8350 RAID Controller cards are
PCI Plug-n-Play (PnP) devices. No changes are necessary in the
motherboard CMOS/BIOS Setup for resources or drive types in
most applications.
Note
4