Fein Balancer 9 08 01 012 00 8 Manual Original página 14

3 41 01 109 06 0.book Seite 14 Montag, 21. Januar 2013 4:01 16
en
14
Original Instructions for Balancer.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Observe the instructions in the text or graphic opposite!
Use protective gloves during operation.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Weight
Variable load
Load, factory setting
Variable load setting (high/low)
Character Unit of measure,
international
l m
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
/min, m/s
For your safety.
Read all safety warnings and all instruc-
WARNING
tions. Failure to follow the safety
warnings and instructions may result
in serious injury from falling down loads.
Save all safety warnings and instructions for future refer-
ence.
Do not use this balancer before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the balancer, should
it be passed on or sold.
Also observe the relevant national health and safety reg-
ulations, for example in Germany, the BGR 500.
Intended use of the balancer:
for commercial use, as weight-compensating, adjustable
suspension device for suitable work equipment in
weather-protected environments.
Unit of measure,
national
m
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
rpm, m/s
Special safety instructions.
Ensure sufficient stability and sturdiness of the suspension
mounting (ceiling, dowels, bolts, hooks ...). Always use the
securing cable as a second, independent fastening point for
protection against falling down. A falling down balancer
with load can lead to serious injuries.
Use and monitor the wire cables and the forged load hooks
in accordance with the relevant regulations.
Adjust the balancer in such a manner that it moves slowly
in the end position with the weight attached. When the
balancer still pulls too strongly in the end position, the
wire cable can become damaged.
In case of a blockage, first determine the cause before cor-
recting the blockage. Malfunctions that are not corrected
properly can cause the load to fall down.
Do not open the balancer. The spring is under pre-tension.
The pre-tensioned spring poses a hazard.
Do not use accessories that have not been especially
designed or released by the device manufacturer. Safe
operation is not ensured only because an accessory fits
your balancer.
Explanation
Max. extension length of the cable suspension
Basic and derived units of measure from the inter-
national system of units SI.