allen+roth LP7942LBZ Manual Del Usuario página 12

WIRING INSTRUCTIONS
3. Slide the receiver unit (N) into the open end of the
hanger bracket (B).
4. Connect the fan and supply wires according to these
steps and the wiring diagram:
– Connect the green wires from the hanger bracket (B)
and downrod (C) to the bare (ground) wire and secure
the connection using a wire connector (DD).
– Connect the black wire from the receiver unit (N)
marked "AC IN L" to the black supply wire and secure
the connection using a wire connector (DD).
– Connect the white wire from the receiver unit (N)
marked "AC IN N" to the white supply wire and secure
the connection using a wire connector (DD).
– Connect the white wire from the receiver unit (N)
marked "TO MOTOR N" to the white wire from the fan
and secure the connection using the wire connector
supplied with the receiver unit (N).
– Connect the black wire from the receiver unit (N)
marked "TO MOTOR L" to the black wire from the fan
using the wire connector supplied with the receiver
unit (N).
– Connect the blue wire from the receiver unit (N) to the
blue fan light wire using the wire connector supplied
with the receiver unit (N).
WARNING: Check to ensure all connections are tight,
including the ground wire, and no bare wire is visible at the
wire connectors except for the ground wire. Do not operate
the fan until the blades are in place. Noise and motor
damage could result.
Hardware Used
DD Wire Connector
3
4
DD
N
x 3
12
B
C
DD
Lowes.com/allenandroth
N
DD
B