Operation; Starting; Feeding Procedure - Skyfood LT-2,0 SUPER GOURMET 2 Manual De Instrucciones

You cannot:
... expect your blender to replace any other kitchen appliance. It is not supposed to make
mashed potatoes, it does not blend egg white or any other cream for covering, it does not
grind raw meat, it does not blend hard pastas and does not extract kernels from fruit and
vegetables.
...process mixtures for too long. Remember that this kind of blender works in seconds and
not in minutes. Therefore, never let your blender working for more than one minute. It is
better to switch it off and check the mixing consistency after a few seconds to avoid over
blending.
... overload the motor with big or heavy portions, once it will decrease the blender's
lifespan. If the motor stops, immediately switch it off, unplug and remove part of the load
before restarting the operation.

3. Operation

3.1 Starting

Start the machine by pressing the Safety Switch N°.03 (Pic. 01). Then adjust the desired
speed using the Speed Control N°.07 (Pic. 01). In case you do not know the appropriate
speed, set to the maximum speed and press the ON/OFF Switch N°. 06 (Pic. 01).
IMPORTANT
NEVER SWITCH THE MACHINE ON WITH EMPTY CUP, BECAUSE IT WILL CAUSE
IRREPARABLE DAMAGES.

3.2 Feeding Procedure

The blenders work in high speed (approximately 25.000rpm, empty).
To feed the blender, proceed as follows:
- Cut the product in small pieces of up to 2 cm size. This process helps on the blending time,
especially for frozen products. When triturating ice, it is recommended to ad some water.
- Remove the Lid – No. 05 (Picture 01).
- Place the product to be processed into the cup No.04 (Picture - 01) with the machine
switched OFF.
- Place the lid back – No. 05 (Picture 01) and switch the machine ON.
7