Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WF-03 Manual Del Usuario

8

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Clean the product when necessary by using a
soft cloth and mild non-abrasive cleanser to wipe exterior.
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe. It is recommended that the reservoir is removed and
cleaned weekly.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral
content of your water. If left unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of white vinegar to a full
reservoir of warm water. Point the handle and tip into sink. Turn unit ON and
run until reservoir is empty. Rinse by repeating with a full reservoir of clean
warm water.
This process should be done every 1 to 3 months to ensure optimal
performance.
AA Battery Care and Disposal
• Alkaline batteries and NiMH rechargeable batteries are acceptable.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the Water Flosser and
properly disposed.
• The supply terminals are not to be short-circuited.
• Do not dispose of batteries in fire.
• The type and quality of AA battery used will impact performance
of the product.
• Replace all batteries at the same time with new batteries of the same
type and brand.
• Replace batteries when there is a noticeable change in performance.
• Remove batteries when the appliance will not be used for a long period
of time.
WARNING: Use of lithium batteries will void the warranty and may also
result in damage to the appliance.

WATER FLOSSER

®