Charging Operation - Dörr LCD-2 Manual De Instrucciones

DÖRR Universal Charger LCD-2
Instruction Manual
Charging Operation
1.
Connect the charger to a power
source using the supplied AC
adapter or car plug. A black line
blinking on the display center
indicates that the charger is
in standby mode.
3.
3.6V / 7.2V Li-Ion Battery
Adjust the charger case to fit the
Li-Ion battery. The LCD indicates
the charging status by blinking.
The battery is fully charged
when it stops blinking.
5.
9V NiMH Rechargeable Battery
Insert the 9V NiMH battery and
make sure to respect the polarity
The LCD indicates the
charging status by blinking. The
battery is fully charged when it
stops blinking. The charger
now changes to trickle mode.
Specifications
Power Input AC adapter AC100-240V, 50-60Hz
Li-Ion Batteries:
Charging Capacities NiMH Batteries:
USB Output:
DÖRR GmbH will not be responsible for any personal loss or injury caused by improper use of this charger. Specifications
are subject to change without notice.
The CE marking complies with the European directives. You can download the relative EU declaration of conformity
with following link: http://www.doerrfoto.de/info/EG-Konformitätserklärungen
DÖRR GmbH Fotomarketing • Postfach 1280 • 89202 Neu-Ulm/Germany
LCD-2 USB
1. Blinking
2. Blinking
Li-Ion
3.6V
3. Blinking
4. Full
LCD-2 USB
LCD-2 USB
3,6-3,7V (DC 4,2V:700mA)
7,2V-7,4V (DC 8,4V:700mA)
2x AA 2,8V und 2xAAA 2,8V (DC 2,8V; 700mA)
1x 9V (80mA)
5V (500mA)
2.
Easily adjustable Contacts and automatic+/- Polarity Detection
LCD-2 USB
Adjust the 2 pins to the connect position of the battery using the
levers on the bottom of the charger. Now place the battery onto the
charger.
4.
2x AA or AAA NiMH
Rechargeable Batteries
Insert the AA or AAA batteries
and make sure to respect the
polarity. The LCD indicates the
charging status by blinking. The
battery is fully charged when it
stops blinking. The charger now
changes to trickle mode.
6.
Charging Your iPhone, iPod, iPad or Mobile Phone
Connect the charger to the device to be charged using the supplied
USB cable. If required, replace the iPhone/ iPad USB against the
Micro USB adapter.
Micro USB Adapter
LCD-2 USB
GB
1. Blinking
2. Blinking
3. Blinking
4. Full
LCD-2 USB
Note: The LCD-2 charger
can charge a Li-Ion
battery and an electronic
device simultaneously
www.doerrfoto.de