Electrical Connection - Eico E20 80 Montaje Y Modo De Empleo

GB INSTRUCTION ON MOUNTING AND USE
Check also the drawings on the initial pages with the alphabetical
and numerical references in the explanatory text.
Closely follow the instructions in this manual. We cannot
accept liability for any faults, detriment or fire damage to the
appliance due to non-compliance with the manual's
instructions. Installation and electrical connections must be
executed by a qualified technician. You should affix the hood
to a wall of sufficient weight-bearing capacity, so not to one
made of plasterboard.

Electrical connection

Make sure that there is a power socket near the hood and
that the system has a 30 mA differential. The mains voltage
must be the same as that on the label inside the hood. The
hood has a 1250 mm power cable with or without plug: if it
does have a plug, connect the hood to an accessible
approved socket; or if it does not (connection direct to the
mains), fit an approved bipolar switch with a minimum
contact opening of no less than 3 mm (accessible). This
installation and electrical connection must be executed by a
qualified technician.
Operation
A C
With the hood switched off, pressing any key will activate the control panel
in stand-by mode. The symbols are backlit by a white light, allowing you
view and select the desired function.
Pressing one of the keys again will start the corresponding function, and its
symbol will light up. After all functions have been switched off, the control
panel will remain in stand-by mode for around 30 seconds and then switch
off automatically.
A: Light ON/OFF key: press this touch sensor to switch on or off the lights
of the hood.
C: Motor ON/OFF key (4 speed): press this touch sensor to switch on the
hood extractor fan at the same speed as it was when last switched off. Use
the „D" and „B" keys to vary the speed (power) of extraction.
B: Decrease extraction speed (power) key: press this touch sensor to
reduce the extraction speed of the hood.
D: Increase extraction speed (power) key: press this touch sensor to
increase the extraction speed of the hood.
E: Timer key: when this touch sensor is pressed, independently of the
extraction speed selected, the timer function will be activated. Press once
to set the timer for 5 minutes, press a second time for 10 minutes and a third
time for 20 minutes. During this phase, the „E" symbol will flash.
To reset the timer, press the motor key, „C"
F: Reset filters key: press this touch sensor to reset the signal that warns
that the metal grease filter (1) is saturated and the charcoal filter (2) should
be replaced.
(1) After 40 hours of using the hood, the „F" symbol will flash to
indicate the necessity of cleaning the metal grease filters.
(2) After 120 hours of using the hood, the „F" symbol will light
up to indicate the necessity of replacing the activated charcoal
filters.
B D E
Sensor function: pressing the „B" and „D" keys at the same time will
activate the sensor. In this mode the extraction speed sets itself automatically
and the „B e D" key flashes intermittently. To return to manual operation,
press either the „B" or the „D" key.
F
„If the remote control unit is changed, the appliance must be
reset to the frequency of the new unit as follows:
1.
2.
supply on again.
3.
lights and release it when the lights come on.
4.
button.
You will then need to wait for about 10 seconds, after
which the hood can be used as normal. Whenever the
power supply is disconnected, you must wait for 10
seconds before using the extractor."
5
1
4
2
3
1: + motor
2: On/Off motor
3: - motor
4: On/Off light
5: Led
Disconnect the power supply to the hood.
Wait 5 seconds and then switch the power
Within the first 5 seconds, press the button for the
Within 5 seconds, press and release the motor