Eldom blax G42 Manual De Instrucciones página 8

GENERAL DESCRIPTION
1. Shaving head with three blades
2. Opening button for the shaving head
housing
3. On/off switch
4. Indicator
5. Socket for the power cable
6. Trimmer
7. Trimmer opening button
TECHNICAL DATA
- power: 3W
- mains voltage: 230V ~50Hz
- charging time: about 8h
- battery: Ni-CD 600 mAh
USING THE APPLIANCE
- The appliance can be used after charging the battery.
- The shaver starts working after switching the switch (3)
- In order to turn off the appliance, the switch (3) should be switched again
- The appliance is equipped with an internal battery. Charging time is about 8 hours.
- In order to increase the battery life-span charging should be done in one uninterrupted
cycle after full discharging
- Power cable should be properly connected to the socket (5).
- Charge is indicated by a control light (4). The indicator light does not turn off when the
battery is charged.
- After charging, the appliance should be disconnected from the mains and the power
cord should be unplugged from the socket (5).
- The appliance is equipped with a trimmer (6) to cut beard , which is activated by the
switch (7).
CLEANING AND MAINTENANCE
- before cleaning, disconnect the appliance from the mains
- do not immerse in water
- do not use heavy-duty or surface-damaging detergents and cleaning products
- wipe the housing with a damp cloth
- after each shaving, empty the blade compartment. For this purpose, remove the mesh cover by
pressing the (7) button. To facilitate cleaning, remove the blades (caution, the blades are sharp!).
SCREENS AND KNIVES REPLACEMENT
To replace the knives and screens, follow the dismantling procedure described in the section
"CLEANING AND MAINTENANCE".
Knives and screens are operating components and should be replaced regularly.
They are not covered by the warranty.
INSTRUCTION MANUAL
ELECTRIC SHAVER G42
1
2
3
4
5
EN
6
7
EN|8