EUROM VENTO 9 Manual De Instrucciones página 11

IMPORTANT
Do not use the fan in a bathroom or wet area. Find a stable, horizontal place for the fan in the
vicinity of a wall socket. Place the vento 16SR on the ground. Ensure that the fan is not within
the reach of children. Never stick objects through the grid. Always unplug the fan from the wall
socket before you move it or carry out maintenance on it!
OPERATION
The fans can be set to different speeds: The Vento 9 has two settings; the Vento 12 & Vento
16(SR) have three settings. All types of fan are equipped with an oscillation function (75°).
If you would like to angle the fan upwards or downwards, the motor block can be angled further
up or down in relation to the foot. Before doing so, however, turn off the fan and remove the
plug from the socket!
If - the fan has been fully assembled
- all connections have been properly secured
- all safety guidelines have been taken into account
you can use the fan.
Vento 9, Vento 12 & Vento 16:
I - Insert the plug into the socket.
II – Select setting: 0=off, 1=standard, 2=strong (Vento 12&16: 3=extra strong).
The output buttons on the (T) models are located on the base; they can be found on the button
unit on the (S) models.
The fan will now begin to work.
III – If required, you may now depress the oscillation button on top of the motor: the fan will now
begin to oscillate through an angle of 75°. Depressing and releasing this button will turn the
oscillation function off. Make sure that hair, clothes, curtains etc. cannot be sucked into the
spinning fan!
Press the 0 button to switch the fan off. If you wish to turn the device off for longer than just a
few minutes, you must also remove the plug from the socket.
Vento 16SR:
Plug it into the wall socket.
1. on/off switch
Push this switch to turn the fan on at its default speed. A second
push = switch-off. If not using the fan for longer than a few minutes
then unplug it from the wall socket.
2. Speed button
Pressing this button switches the fan speed to fast and then to extra
fast.
3. Ventilation Method
By pressing this button you can switch from a constant air flow to
natural, continuously varying ventilation. Use the speed button to
select (me, II or III) for a different variation:
11