Eaton Metalux IB519013EN Instrucciones De Instalación página 2

Installation Instructions - Steeler LED Battery Pack
3. Wire input AC to the fixture, including the unswitched
circuit for the battery pack. Wire according to code.
(Figure 2).
QD
To unswitched
Input AC
circuit
Figure 2.
4. Connect wires coming out of KO hole and push wires
back in to fixture. (Figure 3).
Figure 3.
2
EATON
IB519013EN
Ground
Threaded
Pipe Shown
Connect Battery pack
charging circuit
Installation instructions
5. Cover KO with fitting provided. (Figure 4).
Fitting
Test Switch
Figure 4.
Battery Pack Installation (If equipped with Motion
Sensor)
1. Mount fixture and remote battery pack (use hardware
appropriate for the structure the battery is installed, not
provided with the fixture) (Figure 5).
2. Suspended fixture a minimum of 12" from the ceiling
and position the battery pack off-center from the
fixture.
Review instructions provided by
the battery pack manufacturer
Figure 5.