Declaration Of Conformity - DeWalt DW033 Manual De Instrucciones

E N G L I S H
The following label samples are placed on your laser tool to inform you
of the laser class for your convenience and safety. Please also reference the
Product Instruction Manual for the specifics on your particular product
model.
LASER LASER
1

DECLARATION OF CONFORMITY

The D WALT Tool Co declares that the CE Mark has been
E
applied to this product in accordance with the CE Marking
Directive 93/68/EEC.
This product conforms to IEC 60825-1
For further details please refer to www.D
IEC 60825-1
6
WALT.eu
E
MAINTENANCE
• To maintain the accuracy of your work, check the laser often to make
sure it is properly calibrated. See Field Calibration Check instructions in
your Operators Manual.
• Calibration checks and other maintenance repairs may be performed by
D WALT service centers.
e
• When not in use, store the laser in the kit box provided. Do not store
your laser at temperatures below -20˚C (-5˚F) or above 60˚C (140˚F).
• Do not store your laser in the kit box if the laser is wet. The laser should
be dried first with a soft dry cloth.
CLEANING
Exterior plastic parts may be cleaned with a damp cloth. Although these
parts are solvent resistant, NEVER use solvents. Use a soft, dry cloth to
remove moisture from the tool before storage.
SERVICE
NOTE: Disassembling the laser level will void all warranties on the product.
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers. Have your tool
serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the tool is maintained.
Service or maintenance performed by unqualified personnel may result in a
risk of injury. To locate your nearest D
www.D WALT.eu
E
ACCESSORIES
WARNING:
Since accessories, other than those offered by D
not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
should be used with this product. Accessories that may be suitable for one tool,
may become hazardous when used on another tool.
E N G L I S H
WALT service center go to
e
WALT, have
e
WALT recommended accessories
e
7