Beper 50.002 Manual De Instrucciones página 11

EN
Ironing system with pressure gauge Use instructions
Unscrew the safety cap and fill the tank with about 0.75 litres of water with the help of the funnel and make sure
it does not overflow.
Screw the cap back and make sure it is firmly closed, otherwise it is possible to run risky steam leaks around
the cap.
Plug the power cord into a power outlet.
Turn on the iron and the boiler using the appropriate switches.
Once finished ironing, wait for the entire ironing system (iron and boiler) to cool down and drain the water left in
the tank.
Temperature setting
Always consult the washing and ironing label inside the items to be ironed.
The number of dots shown in the adjustable iron thermostat indicate the temperature from the lowest (•) to the
highest (•••).
If you do not know the type of fabric to be ironed, it is advisable to iron part of it, normally not visible when the
item is worn, starting from the minimum temperature, then finding the most suitable temperature. It may happen
that the garment becomes shining, in this case it is necessary to suspend the ironing in order not to ruin it and
to iron the fabric on reverse.
Attention: pay close attention to the symbol : the fabric (garment) must not be ironed.
Steam ironing
Note: the steam indicator light may, from time to time, turn on and off during use of the boiler. This is
completely normal and indicates that the machine is maintaining a correct and constant pressure.
Connect the electric cable to the socket.
Set the iron temperature to maximum.
Switch on both switches (iron and boiler).
Wait for the "steam ready" light to come on, this will happen when the boiler reaches 3Bar, you can see it using
the gauge indicator.
Press the "steam shot" button on the iron: a shot of steam will come out of the holes in the plate, the intensity of
which can be adjusted using the special knob.
By using the continuous steam system it is possible to keep the jets of steam without having to press each time
the appropriate button. As steam is used, the boiler pressure will tend to decrease, as shown by the pressure
gauge, whose level will show the decrease in pressure. Release the button to stop the steam.
Note: in the absence of water it will not be possible to generate steam, it will be necessary to recharge
the tank as indicated in the specific paragraph.
It is recommended to refill the tank when it is completely cooled. In any case, we recommend carefully pouring
only small amounts of water at a time to avoid the risk of it escaping violently if the tank is still too hot.
During the initial operation of the iron and until the temperature has stabilized, some drops of water mixed with
steam may escape from the plate. It is therefore advisable to direct the first jets onto an old cloth until the steam
is uniform and stable.
Dry ironing
Connect the cable to the power outlet, turn on only the iron switch. Adjust the iron temperature by turning the
thermostat knob to the desired level.
Safety cap
The appliance is equipped with a safety cap that prevents children from opening the tank which, in the presence
of residual pressure inside it, would be very dangerous. This is an important and indispensable safety device
which, together with a correct tank refilling procedure, will make the use of the iron and boiler safer.
Filling the tank
When the water in the tank is finished (no more steam comes out), refill as follows:
Position the knob on the maximum steam intensity.
Press the "steam shot" button so that the residual steam in the tank comes out completely.
Completely switch off the ironing unit (iron and boiler) and disconnect the plug from the socket.
11