Beper 40.500 Manual Del Usuario página 12

General Recommendations for Use
The intensity control allows you to regulate the intensity of the massage as required. Start at a gen-
tle speed and progressively increase it, depending on your sensitivity to the massage.
If using special treatment creams (firming and anti­cellulite creams, for example), apply these after
the massage, which prepares the skin and its tissues to absorb the ingredients.
We always recommend you use a moisturising lotion after the massage. You can apply the cream
using either the "wavy surface" head (10).
Do not apply creams when using the protective fabric (11) on the "wave- shape" head.
Recommended Treatment Duration
Apply a 2-3 minute massage on the abdomen and a 5 minute massage on the legs and buttocks.
You may establish the duration of the massage depending on your sensitivity.
The total treatment must be approximately 15 minutes.
Do not use the appliance for more than 15 minutes. Using the appliance continuously for more
than 15 minutes may cause it to overheat, reducing its life. Let it cool down before continuing
use.
Use this appliance every day until you notice the results, which may be subsequently maintained
by using it three days a week. To maintain the results over the long-term, adapt your lifestyle habits
and food.
Use
This appliance has been designed to provide therapeutic massages to help prevent cellulite, fluid
retention and flaccidity. Do not use it for any other purpose.
Massaging with this appliance generates a thermal effect in the treated area; this thermoactive
effect helps to mobilise the accumulated fats and toxins. To gently intensify the treatment, the ap-
pliance has an infrared light that slightly increases the thermal action of the appliance.
Plug in the appliance (fig. B).
Move the switch (C) to the massage position (fig.C2) or to the "massage + infrared position (IR)
position" (fig.C3) according to the desired treatment.
Fit the correct head, (7), (8), (9), (10) for the treatment you require to the adaptor (5) (fig. D).
To remove the head, pull firmly at the edge to release the fastening tabs. (fig. D).
To choose which massage head to use, follow the instructions in the"Treatment Type" table.
You may alternate the use of different heads during the same massage.
Set the intensity of the massage using the intensity control (3) and place the massager on the area
on which you are going to work.
Set the intensity of the massage using the control (3), according to the area to be treated and its
sensitivity to massage (see the "Treatment Type" table).
To do so, turn the control to one side or another with your finger, depending on the desired intensity
(fig. 4).
Hold the massager firmly with both hands and move it over the skin in the direction of the blood
circulation (see "Massage Direction").
Without pressing too hard, simply glide the massager over the area to be treated.
When you have finished using the massager, move the switch (2) to the "off" position (fig.C1).
Unplug the appliance.
Massage Direction
Always glide the massager over the skin in the direction of the blood circulation.
Legs
Place the appliance on the thigh, close to the knee, and glide it gently upwards towards the hip
(fig.F).
12